AIR BLOW GUN

AIR BLOW GUN DG 10

Quick View

• AIR BLOW GUN DG 10

  

  Air Blow Guns Information

  Air blow guns attach to air lines for the manual actuation and/or control of air discharge. They are used primarily for:

  • debris removal and purging
  • non-contact part cleaning and drying
  • general laboratory or industrial applications

  Most air blow guns are made of plastic or metal and include an ergonomic grip or handle. A steady stream of compressed air is delivered through a sturdy metallic nozzle. Air blow guns that are equipped with an internal fail-safe pressure mechanism shut off automatically if the gun is dropped or the lip is blocked. Integral pressure relief valves are used to blow off excess pressure before discharge. In the United States, products that meet or exceed standards from the Occupational Safety and Health Administration (OSHA) are commonly available. Typically, manufacturers indicate whether products are suitable for high volume applications, or include a threaded discharge port or vacuum attachment.

  Specifications

  Specifications for air blow guns include pressure capacity and air line connection type. Pressure capacity, or maximum rated pressure, is rated at the air inlet and measured in pounds per square inch (psi). Many types of air line connectors are available. Quick-release connectors contain fittings that are attached internally. By contrast, push-on connectors include barbed ferrules. Air blow guns use several types of national pipe thread (NPT) connectors, most of which are inch-based and female. Important NPT measurements include threads per inch (TPI) and outside diameter (OD):

  • 1/8 in. NPT connectors have 27 TPI and an OD of 0.405 in.
  • 1/4 in. NPT connectors have 18 TPI and an OD of 0.540 in.
  • 3/8 in. NPT connectors also have 18 TPI, but an OD of 0.675 in.
  • 1/2 in. connectors have 14 TPI and an OD of 0.840 in.

  #10-32 NPT threads are also available. Air line connections that can swivel or pivot are suitable for applications that require versatile positioning.

  Types

  Air blow guns vary in terms of nozzle type and actuation style. Standard safety nozzles are suitable for general-purpose applications. Small-diameter nozzles can be inserted into tight openings. Nozzles with rubber tips prevent the marring of surfaces while nozzles with flexible tips can be guided directly to the application point. Air blow guns with extended, straight nozzles provide longer reach. Devices with extended, angled nozzles are designed for use in difficult-to-reach locations. Venturi nozzles contain small holes that allow the discharge to draw ambient air to increase the airflow. Air screens are often used to minimize particle blowback. In terms of actuation, most air blow guns include a discharge lever that is in-line with the air hose and actuated by the thumb. Pistol or trigger-style devices are also available. With these devices, the actuator is located at a right-angle to the air supply hose and incorporates an ergonomic handle. Button-actuated air blow guns are also available.

  
  Feedback Form

  x